Wavetronix Click 331 (unmanaged ethernet switch) (CLK-331) - Manuel d'utilisateur télécharger pdf (Page 2)

8,665,113; and Cdn. Pat. Nos. 2,461,411; 2,434,756; 2,512,689; and Euro. Pat. Nos. 1435036; 1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click,

Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are trademarks or registered trademarks of their respective hold-

ers. Product speciﬁcations are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability related to its use.

Ground the device

Wire communication

e Click 330/331 have two possible communication ports.

˽ RJ-45 jacks (Click 330 and 331) – Attach Ethernet cables here

˽ SC ber optic connectors (Click 331) – Attach ber optic cables by pushing the connector down until it

engages with a click

e device has a grounding foot, so as long as

the DIN rail is properly grounded, the device

will be grounded as well.

However, for additional protection, the switch

can be grounded via an eyelet ring on the top

of the device.

WX-500-0188

Monitor LEDs

e devices have three dierent kinds of LEDs.

˽ At the top of each device are two green LEDs

labeled US1 and US2, used for monitoring the

power supply. US1 monitors the rst power supply

(the one using the screw terminal marked US1)

and US2 monitors the second (redundant) power

supply.

˽ Each Ethernet port has two LEDs that show the data transmission speed of that port, as shown in the

table below. ese LEDs are labeled 100/ACT and 1000/ACT. If the LED is on, there is an electrical link.

If the LED blinks, there is currently network trac at that speed.

LED 10 Mbps 100 Mbps 1000 Mbps

100/ACT On or blinking On or blinking O

1000/ACT On or blinking O On or blinking

˽ e ber ports on the Click 331 each have an LED labeled 1000 LNK/ACT. If this LED is on, there is a

valid connection through that port. If the LED blinks, there is currently network trac at 1000 Mbps.

Status Meaning

On Supply voltage is in an acceptable range

O Supply voltage is too low

1 2

Commentaires sur ces manuels

Pas de commentaire

Wavetronix Click 331 (unmanaged ethernet switch) (CLK-331) - Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Wavetronix Click 331 (unmanaged ethernet switch) (CLK-331) -