Wavetronix SmartSensor 105 (SS-105) - User Guide Manuel d'utilisateur télécharger pdf (Page 60)

In this chapter

 Lane Conﬁguration – Automatic

 Lane Conﬁguration – Manual

 Verifying Lane Conﬁguration

Setting up lanes is simple in SmartSensor Manager because the software will do it for you

with the click of a button. Additionally, if SmartSensor Manager is unable to correctly

congure due to barriers, obstacles or irregular lanes, you can use the Manual Congura-

tion mode to adjust.

Note

Free-ﬂowing trac in each lane is required for proper conﬁguration. Light or sporadic

trac may result in slower conﬁgurations.

Lane Conﬁguration – Automatic

Follow the steps below to automatically congure lanes in SmartSensor Manager:

1 Select Edit > Lane Conguration.

2 Once the Lane Conguration page opens, click on the Automatic button.

3 If you would like to set constraints on the conguration through the Edit Range

Blinders or Manage Gain buttons, do so now. For more information on these options

see the sections on them in the following pages.

Lane Setup 6

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 98 99

Pas de commentaire

Wavetronix SmartSensor 105 (SS-105) - User Guide Manuel d'utilisateur Page 60