Wavetronix SmartSensor Matrix Guide de l'utilisateur télécharger pdf (Page 91)

90 CHAPTER 9  VERIFICATION

Vehicle detections in a stopped queue are represented by a stationary light blue rectangle.

Channel Indicators

When detections enter a zone, they will cause the indicators for the channel mapped to that

zone to turn red. To see the zones mapped to a particular channel, select that channel by

clicking on its indicator (see Figure 9.2). Active zones for the selected channel will be red;

inactive zones for the selected channel will be gray. e channel type will be indicated by

the letter under the channel number (C = Counting, N = Normal, P = Pulse). An “I” will

also be added if the channel is inverted. Click on the yellow button on either side of the

channel indicators to see channels 9–16.

Figure 9.2 – Channel Veriﬁcation

Note

Only the zones for selected channels will appear. If zones are not mapped to any

channel, they will not be seen in the Veriﬁcation window.

To see the delay/extend, logic and detector input/phase settings for a single zone, click and

hold on a channel indicator and the following window will appear (see Figure 9.3).

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 115 116

Pas de commentaire

Wavetronix SmartSensor Matrix Guide de l'utilisateur Page 91