Wavetronix SmartSensor HD (101-0415) - User Guide Manuel d'utilisateur télécharger pdf (Page 23)

22 CHAPTER 2  CONNECTING POWER AND SURGE

Smart

Sensor

Main trac cabinet

Pole-

mount

box

Earth groundEarth ground

120

VAC

Figure 2.2 – Underground Cable Run

Wiring the Click 200

ere are two cables that may be used with your sensor, the 8-conductor cable and the

9-conductor cable. Which one you use is based largely on the connector on your SmartSen-

sor HD—that is, the connector where the cable will be plugged into the sensor.

ere are two dierent connectors that may be found on a SmartSensor HD:

 e 10-pin connector is used with the SmartSensor HD. It currently only comes in-

stalled on the 8-conductor cable.

 e 26-pin connector is used with SmartSensor HD Legacy and retrotted HDs. It can

be installed on the 8-conductor cable or the old 9-conductor cable.

Note

There may be compatibility issues if you use a 8-conductor/26-pin connector cable

with a SmartSensor HD that was manufactured in or before 2008. Contact Wavetro-

nix Technical Services for details and assistance.

e wiring for these two cables is almost identical; the dierences are pointed out on the

following page.

Note

If you have an underground cable run that stretches more than 600 ft (182.9 m), you will

likely need to use a dierent cable; in that case the colors won't match the ﬁgure below.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 88 89

Pas de commentaire

Wavetronix SmartSensor HD (101-0415) - User Guide Manuel d'utilisateur Page 23