Wavetronix Command DataView (CMD-DV) - User Guide Manuel d'utilisateur télécharger pdf (Page 36)

CHAPTER 4  DATA PAGE 35

time.

4 Select an aggregation level—either 5-, 15- or 60-minute bins. In cases where the data in

Collector is in a smaller interval size than the selected aggregation level, DataView will

automatically aggregate the data to the desired bin size.

5 Click Import All to import data for all stations, or Import Selected to import data for

the selected stations only.

Note

Stations will need to be assigned one or more sensors on a Collector machine in order

to import data correctly. Stations without a sensor/lane assignment will not import

data, even if selected. For more information on mapping stations to Collector sensors

and lanes, see the Collector Settings section later in this chapter.

Once the import operation has begun, you do not need to remain on the Collector page.

Check the Notify me via email when complete checkbox before starting the import opera-

tion to receive an email when the import is complete. Use of this features requires a valid

email address and email server to be registered with DataView in the System > Settings

section.

Auto Tab

For convenience, import from Command Collector services can be done automatically on

the Auto tab. To activate auto-import, check the Enable Auto Data Import From Collec-

tor checkbox (see Figure 4.3)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 105 106

Pas de commentaire

Wavetronix Command DataView (CMD-DV) - User Guide Manuel d'utilisateur Page 36