Wavetronix Click 342 (lean managed ethernet switch) (CLK-342) Manuel d'utilisateur télécharger pdf (Page 10)

CHAPTER 1  CLICK 340/341/342 MANAGED SWITCHES 9

 IGMP snooping and querier function

 Port mirroring

 Port statistic

 Link status via alarm contact

 MAC address clearing

 Proprioratary

 Rapid Spanning Tree

Installing the Click 340/341/342

Mount the managed switch on a DIN rail; to avoid contact resistance, only use clean, cor-

rosion-free DIN rails. Before mounting the modules, an end clamp should be mounted on

the le-hand side next to the managed switch to stop the modules from slipping on the

DIN rail. e end clamp should only be mounted on the right-hand side once the managed

switch has been mounted.

Follow the steps below to install the Click 340/341/342 onto the DIN rail (see Figure 1.4):

1 Place the module onto the DIN rail from above (A). e upper holding keyway must

be hooked onto the top edge of the DIN rail. Push the module from the front towards

the mounting surface (B).

Figure 1.4 – Attaching the Switch to the DIN rail

2 Once the module has been snapped on properly, check that it is xed securely on the

DIN rail. Ensure that the positive latches are facing upwards, i.e., snapped on correctly.

Removing the Device

Follow the steps below to remove the Click 340/341/342 from the DIN rail (see Figure 1.5):

1 Remove all connectors.

2 Pull down the positive latches using a suitable tool (e.g., screwdriver). Both positive

latches remain snapped out.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

Pas de commentaire

Wavetronix Click 342 (lean managed ethernet switch) (CLK-342) Manuel d'utilisateur Page 10