Wavetronix SMARTSENSOR 105 Manuel d'utilisateur Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 27
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
Page 1
SmartSensor HD
Installation and Configuration
I. Connect to sensor
a. Connect the SmartSensor HD cable to the battery using the positive and negative
battery terminals
b. Connect serial cable from SmartSensor HD cable to laptop COM port
c. Open the SmartSensor HD Manager on the laptop
II. Connect using the serial connection. Ensure proper sensor alignment
a. On the main screen, click “Lane Setup”
b. Click “Sensor Alignment”
c. Adjust the sensor according to the sensor displayed in the “Sensor Alignment” window.
A green arrow means the sensor is positioned correctly for optimal performance; a
yellow or red arrow means the sensor in NOT correctly aligned with the roadway.
III. Lane configuration
a. Automatic configuration
1. From the main screen, select “Lane Setup” Æ ”Lane Configuration”
2. Click the “Tools” icon and select “Clear Edit Area”
3. Click the “Tools” icon again and select “Restart Auto Cfg.”
Note: This step could take several minutes depending on the
amount of traffic.
4. Once the SmartSensor HD has detected vehicles and created lanes, click “OK” and
save the changes to the configuration.
5. To verify that the lanes have been configured properly, close the “Lane
Configuration” window and select “Lane Verification” from the “Lane Setup” menu
6. If the sensor is unable to configure itself to your satisfaction, use manual
configuration.
b. Manual configuration
1. From the “Lane Setup” menu, select “Lane Configuration”
2. Click on a lane to change the lane name, lane direction, and lane activity
3. Uncheck the ‘Activity’ box to de-activate the lane
¾ Lanes can be adjusted by clicking anywhere inside the lane and using the
adjustment tools
4. Side bars on either side of the ‘Lane Configuration’ window have several different
modes. A list of the modes can be seen by holding down the sidebar button
¾ Auto Cfg. – shows the lanes that were automatically configured by the sensor
¾ Saved Cfg. – shows the lanes that are saved on the sensor
¾ Scale – shows the distance in feet from the SmartSensor HD to each lane
¾ Peaks – shows the relative occurrence of events
¾ Tracks – shows the vehicle paths for low-traffic lanes
5. Lanes can be added by clicking any area where a lane is desired and selecting “Add
Lane” from the options in the pop-up box
6. Deleting lanes can be done by clicking anywhere inside the lane and selecting
“Delete Lane” from the options that appear.
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27

Commentaires sur ces manuels

Pas de commentaire