Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuel d'utilisateur télécharger pdf (Page 104)

APPENDIX 103

during the threading process, connect the plug and coupling ring to a sensor connec-

tor receptacle.

9 Press all of the connector parts together. read the strain relief onto the back shell.

10 Tighten the strain relief screws on the back.

Figure A.2 – Connector Sub-assembly Parts

Appendix B – Cable Lengths

It is recommended that the sensor be powered by 24 VDC to achieve reliable operation up

to 500 . (152.4 m) away. Table B.1 lists maximum cable lengths for 12 and 24 VDC.

Power Wire Gauge 24 Volts 12 Volts

20 AWG 500 ft. (152.4 m) 90 ft. (27.4 m)

Table B.1 – Maximum Cable Length for Power (ft)

For communications, both of the sensor’s RS-485 communication ports operate at 9600

bps.

Note

Contact Wavetronix Technical Services if you have a need for a cabled connection over

500 ft. (152.4 m).

Appendix C – Click 221 User Reference Guide

e Click 221 is a DC 8 A surge protector (8 A is the maximum rating of a T-bus connec-

tor). e DC source voltage and PE (protective earth) should be wired into the screw ter-

minals on the bottom side of the device. A 12 AWG protective earth wire is recommended.

e device works with up to 8 A of continuous current at a maximum of 28 VDC.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 116 117

Pas de commentaire

Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuel d'utilisateur Page 104