Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuel d'utilisateur télécharger pdf (Page 60)

CHAPTER 5  COMMUNICATION 59

Figure 5.10 – Error Log

Upgrading the Sensor’s Embedded Software

Aer clicking the Connect button, the soware will check to see if your soware version

matches the version of the sensor’s embedded soware. If a discrepancy is detected, the Ver-

sion Control screen may appear asking you to install rmware upgrades (see Figure 5.11).

If you think you have reached this screen in error, clicking the Recheck button will have the

soware retry and ensure that there has not been a communication issue. Clicking the De-

tails button will display the current sensor and soware information. Click the UPLOAD

FIRMWARE button to upgrade the soware.

Checking the Backup/Restore checkbox will back up all of the settings for the sensor(s)

before the upload. When the upload is nished, it will restore the settings. Checking the

Upload to all sensors checkbox will broadcast the upgrade to all the sensors on the control

bridge. Check the Disable fast pacing checkbox if you are connected using Bluetooth or

other devices with a slow connection speed (see Figure 5.11).

Figure 5.11 – Sensor’s Embedded Software Upgrade (left) and Details Table (right)

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 116 117

Pas de commentaire

Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuel d'utilisateur Page 60