Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuel d'utilisateur télécharger pdf (Page 53)

52 CHAPTER 5  COMMUNICATION

Figure 5.3 – Serial Connection

e rst time you connect to a sensor, the default Sensor ID will be the last seven digits of

the sensor’s serial number. However, the names in the Location and Approach elds will

be set to default values.

Note

It is recommended that you label the service end of each SmartSensor Matrix cable

when the cable is pulled so that the approach the sensor is monitoring can be docu-

mented. You may need to power down all sensors except for the one you are conﬁgur-

ing in order to determine which approach it is monitoring.

If you have problems connecting:

1 Make sure that all power and communication wiring is correct.

2 Check the port settings (Port ID).

Connection failure can occur for various reasons; if a failure occurs repeatedly, call Wa-

vetronix Technical Support for assistance.

Once you have selected a sensor from the device list, you can click again on that row to

bring up a Sensor Info pop-up (see Figure 5.4). e information in the Sensor Info screen

cannot be edited.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 116 117

Pas de commentaire

Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuel d'utilisateur Page 53