Wavetronix Command Collector (CMD-DCx) - User Guide Manuel d'utilisateur télécharger pdf (Page 112)

CHAPTER 9  DRIVER REFERENCE 111

Figure 9.4 – 3M 900 Series Trac Loop Custom Panel

Custom Fields

 Location – A description of the place where the sensor is installed, which can be a

name or geographic coordinates.

 Description – A description of the sensor’s location.

 On Ramp – Checkmark this eld if the sensor is being used on a one-lane ramp.

EIS RTMS X2/X3

e RTMS X2/X3 is a radar device that provides true presence detection of vehicles in

multiple zones or lanes.

e RTMS protocol does not provide any means of obtaining conguration information

through driver commands. Most of the conguration, including lane information, will need

to be entered manually through the Web interface control when adding RTMS units to Col-

lector (see Figure 9.5).

Figure 9.5 – EIS RTMS X2/X3 Custom Panel

Custom Fields

 Location – A description of the place where the sensor is installed, which can be a

name or geographic coordinates.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117

Pas de commentaire

Wavetronix Command Collector (CMD-DCx) - User Guide Manuel d'utilisateur Page 112