Wavetronix Command Collector (CMD-DCx) - User Guide Manuel d'utilisateur télécharger pdf (Page 113)

112 CHAPTER 9  DRIVER REFERENCE

 Description – A description of the sensor’s location.

 Serial Number – e sensor’s serial number.

 Version – e sensor’s rmware version.

Lane Information (Required)

 Direction – Indicates not only the direction of trac in each lane, but also how many

lanes are active and how many and which lanes the sensor is capturing data from.

 Description – ese elds are optional.

Lane information will need to be entered in order for Collector to interpret and store the

lane data correctly. Set the Direction eld for each lane (one to a maximum of eight) to be

a value other than “OFF” to activate the lane.

Autoscope

e Autoscope is a camera with a video detection system that delivers trac data collection

and incident detection (see Figure 9.6). e Detector ID elds allow you to enter the zone

numbers you want to monitor.

Figure 9.6 – Autoscope Custom Panel

Custom Fields

 Location – Allows you to enter the camera’s location. is can be a description or geo-

graphical coordinates.

 MVP ID – Autoscope’s ID for the camera. is will need to be set manually and can be

found using the Autoscope Network browser. e MVP ID is needed for collection pur-

poses because Collector does not communicate directly with the Autoscope camera.

 Units – Allows you to select the units being used by the device.

 Sensor Interval – e onboard sensor collection interval in seconds.

Data Fields Enabled

e Data Fields Enabled settings tell the collection which elds to look for. ese check-

1 2 ... 108 109 110 111 112 113 114 115 116 117

Pas de commentaire

Wavetronix Command Collector (CMD-DCx) - User Guide Manuel d'utilisateur Page 113