Wavetronix Command Translator (CMD-DT) - User Guide Manuel d'utilisateur télécharger pdf (Page 45)

44 CHAPTER 4  ROUTES PAGE

Routes can be divided into segments which also have a start and end mile marker. Routes

can be composed of any number of segments. By default, a route will have one segment that

covers the entire length of the route. e route graphic will usually display the start and end

mile markers for each of the segments in light gray, as well as the segment distance in the

middle of each segment (both of these can be toggled on/o according to user preference).

Figure 4.8 shows a route with segments added.

Figure 4.8 – Route With Segments

Segments can be edited by clicking directly on them in the route graphic. Selecting a seg-

ment will bring up a segment option panel directly below the graphic (see Figure 4.9)

Figure 4.9 – Selected Segment Options

Note

To see the segment option panel, you must have the Assets tab (beneath the sege-

ment graphic) open. If Travel Point or Override is open, the panel won’t appear.

To change the size of the segment, or where it starts and ends, change the Start Mile and

End Mile text elds and click Change. e segment start and end values cannot exceed the

bounds of the start and end mile markers of the route. Making a segment shorter or longer

will adjust the length of the neighboring segments as needed to accept the new length. Seg-

ments must have a distance greater than zero. Segment lengths can be decimal values (up

to two decimal places).

You can also use the Change button for the Speed Limit text eld; you can use this eld if

an individual segment has a dierent posted speed limit than the rest of the route. is eld

defaults to the speed limit of the entire route, as entered in the Route Conguration area in

the top le of this page.

To remove a segment from a route, select it and push Remove. e distance previously cov-

ered by that segment will be integrated into another segment. When you click Remove, the

Remove Segment window will appear (Figure 4.10) to let you choose whether the segment

should combined with the one on the right or the one on the le. As the window says, if the

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 155 156

Pas de commentaire

Wavetronix Command Translator (CMD-DT) - User Guide Manuel d'utilisateur Page 45