Wavetronix Command Translator (CMD-DT) - User Guide Manuel d'utilisateur télécharger pdf (Page 50)

CHAPTER 4  ROUTES PAGE 49

available above the grid (e default option is All). Selecting a new lter option will show

only those sensor listings that meet the selected criteria—other sensors will not be dis-

played. Additionally, the search eld above the grid will allow users to enter a search string,

and the grid will display all sensors that contain that search string in any of its identication

elds.

Aer selecting one or more lanes or approaches for an entry, ll in the Asset Name and

Mile Marker elds, then push Add. e selected entry will be added to the Asset list aer

the window closes.

Removing Assets from Asset Group

To remove an asset from an asset group, click on the Remove link on the right side of the

grid row. Removing an asset from an asset group will also remove that asset from any routes

that have included that asset in its route denition.

Adding Assets from an Asset Group to a Route

To manage assets within a route, select a route and then select the Asset tab in the bottom

panel (see Figure 4.16).

Figure 4.16 – Asset Tab

All assets from all asset groups are listed in the grid, with the following elds:

 Name – Asset name

 Mile # – Mile marker representing the asset location

 Type – Asset type, either Point, Trap, Delay, or Probe

 Asset Group – Asset group this asset belongs to

 Assigned to Route – Either “included” or “excluded”

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 155 156

Pas de commentaire

Wavetronix Command Translator (CMD-DT) - User Guide Manuel d'utilisateur Page 50