Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manuel d'utilisateur télécharger pdf (Page 104)

CHAPTER 8  VERIFY CHANNELS-ALERTS-ZONES 103

Tri-view

Congure the tri-view display by clicking and holding on the roadway display selector

while the tri-view mode is active. e desired modes can then be selected on the Tri-view

Trackers screen (see Figure 8.17).

Figure 8.17 – Tri-view Trackers for Advance (left) and Advance Extended Range (right)

e discovery range is abbreviated “D. Range” in the tri-view menu and abbreviated “Disc.”

in the selector bar. Priority Level is abbreviated “P. Level” and “Level” respectively.

Any mode can be assigned to display on the le (1), middle (2) or right (3) side of the

tracker display (see Figure 8.17 and 8.18). A mode cannot be displayed in more than one

location and removing a check mark will disable the corresponding column.

Figure 8.18 – Tri-view Display Mode

Note

The tri-view Qualiﬁed Count (Q. Count) data shows only part of the data displayed in

the Qualiﬁed Count display mode. The Qualiﬁed Count displays the count, but does

not display the amount of trackers needed to meet the deﬁned requirements; the

Dynamic Density displays the percentage, but does not display count.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 147 148

Pas de commentaire

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manuel d'utilisateur Page 104