Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manuel d'utilisateur télécharger pdf (Page 59)

58 CHAPTER 5  SENSOR SETTINGS

Figure 5.2 – General Tab

 Serial Number – Contains the sensor serial number and can only be edited if you are

in the Advanced Sensor Setup mode (conatct Wavetronix Technical Services for more

information).

 Sensor ID – Allows you to enter a multi-drop address for the sensor. e ID default

is the last four digits of the sensor serial number. e sensor ID can be changed, but

no two sensors should have the same ID; the ID must be unique for all sensors on a

multi-drop bus.

 Description – Allows you to enter a description for each sensor (i.e. its function, ap-

plication or intended use). Limited to 32 characters.

 Location – Allows you to enter the location of the sensor or the approach. Limited to

32 characters.

 RF Channel – Displays which radio frequency channel (or non-interference channel)

the device is transmitting on. Using multiple SmartSensor Advance devices in close

proximity will require each one to be set to a dierent RF channel. Similarly, using

multiple SmartSensor Advance Extended Range devices in close proximity will require

each one to be set to a dierent RF channel. However, a SmartSensor Advance device

will not interfere with a SmartSensor Advance Extended Range device, even if they

are on the same RF channel. is is because the hardware used to transmit the Digital

Wave Radar signal is congured dierently on the dierent devices.

Note

It is recommended that the sensor's detection sensitivity be reconﬁgured after

changing from one RF channel to another.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 147 148

Pas de commentaire

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manuel d'utilisateur Page 59