Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manuel d'utilisateur télécharger pdf (Page 45)

44 CHAPTER 4  COMMUNICATION

Figure 4.1 – SSMA Main Screen

e rst step is to make a connection to the sensor. e following three types of connections

can be made:

 Serial connection – Made using RS-485 communication.

 Internet connection – Made using an IP address and Serial-to-Ethernet adapter.

 Virtual connection – Made for convenience in learning and demonstrating SSMA

functionality.

Communication settings are stored in the system registry each time a connection is estab-

lished. Aer the rst connection is made to the SmartSensor Advance, the SSMA soware

will save the connection settings that were used. Click the lightning bolt icon on the right

side of the communication job area to make a connection using the most-recently-used

parameters stored in the registry.

Serial Connection

1 Click on Communication to access the Communication window (see Figure 4.2).

2 Select the Serial tab.

3 Set Port and Speed to the desired settings. e SSMA soware defaults to 9600 baud;

this baud rate is recommended and most likely will not need to be changed. Click the

Advanced… button for additional serial settings.

4 Click the Connect button.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 147 148

Pas de commentaire

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manuel d'utilisateur Page 45