Wavetronix SMARTSENSOR 105 Guide de l'utilisateur télécharger pdf (Page 17)

16 CHAPTER 1  INSTALLING THE SMARTSENSOR MATRIX

One swivel joint is used to pan the sensor eld of view left or right and the other swivel

joint is used to tilt the sensor down towards the roadway. If you are not using the double

swivel-mount, make sure the pole straps are adjustable at this point in the installation

process.

Attaching the Sensor to the Mount Bracket

Use the following steps to securely fasten the sensor to the mount bracket:

1 Align the bolts on the sensor’s backplate with the holes in the mount bracket. e

eight-pin connector receptacle on the bottom of the sensor should be pointing towards

the ground.

2 Place the lock washers onto the bolts after the bolts are in the mount bracket holes.

3 read on the nuts and tighten (see Figure 1.2)

Figure 1.2 – Attach the Sensor to the Mount Bracket

Caution

Do not over-tighten the fasteners.

Aligning the Sensor to the Roadway

e sensor’s beams fan out 45° to the left and 45° to the right, creating a 90° corner radar

eld of view. In most applications, you will want to position the corner radar so that its 90°

footprint covers all lanes approaching the stop bar (see Figure 1.3).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 106 107

Pas de commentaire

Wavetronix SMARTSENSOR 105 Guide de l'utilisateur Page 17