Wavetronix SMARTSENSOR 105 Guide de l'utilisateur télécharger pdf (Page 84)

CHAPTER 8  ZONES & CHANNELS 83

Figure 8.3 – Zones & Channels Menu Bar

e Zones & Channels menu bar contains the following options:

 To Main Menu – Returns you to the main menu.

 Save Conﬁg – Saves the zones and channel mapping to the sensor.

 Undo Changes – Undoes changes made to the zones and channels.

 Edit Zone – Allows you to move a zone and specify the channels to which it is mapped.

 Zone/Channel Map – Allows you to map zones to channels.

 Edit Channel – Allows you to map channels and change extend and delay settings.

 Output Settings – Allows you to change extend and delay settings for each channel.

 Place AutoZones – Allows you to easily place one zone per lane at each stop bar.

How to use these menu options will be covered in the next section.

After the conguration is complete, click the Save Cong button to save the changes to

the sensor. If you attempt to leave the Zones & Channels view before saving your changes,

you will be presented with the following prompt:

Figure 8.4 – Save Changes Dialog

Placing Zones

Zones can also be placed by dragging them from the stack on the edge of the view to a

location within the view. e boundaries of the zones can be moved by selecting the zone,

clicking on one of the corners and dragging it to a new location. e rst ten automatically

placed zones are also mapped to the rst ten detection channels respectively.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 106 107

Pas de commentaire

Wavetronix SMARTSENSOR 105 Guide de l'utilisateur Page 84