Wavetronix SMARTSENSOR 105 Guide de l'utilisateur télécharger pdf (Page 99)

98 CHAPTER 10  TOOLS

Figure 10.4 – Rack Card Tool Serial Settings

2 After you have entered the correct settings, close the Serial Settings window and click

the Search button.

3 Once a list of devices appears, click on the desired row. You can identify a device by its

ID, Device, Description or Location elds. If you would like to communicate to all the

devices, select All Rack Cards in the device column.

Status

e Status eld indicates whether the rack card is operating normally or whether it is in

fail-safe mode. If the device is in fail-safe mode, the text message may help you understand

why the device is in fail-safe. For example, if the text reads “Failsafe Initializing,” this in-

dicates that the rack card has never seen any detection call messages since it was rebooted.

If the message reads “Failsafe Timeout (No Data),” this indicates that the rack card was

previously receiving detection calls, but hasn’t received any in the last 10 seconds or more.

e message will always say "Timeout: (No Data)” when you are connected to the Rack

Card Tools.

Firmware Version

e Firmware Version eld lists the version of the rack card rmware. When you would

like to refresh the status of these elds, click the associated Refresh button. If you are com-

municating with all devices, the status and rmware version elds are not applicable (N/A).

Signal Cards Switch

You can use the Signal Cards toggle switch to help single out devices. When the switch is

ON, all main menu LEDs on the selected devices will begin ashing. If you have selected

All Rack Cards, then the main menu LEDs of every card connected on the bus will begin

ashing.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 105 106 107

Pas de commentaire

Wavetronix SMARTSENSOR 105 Guide de l'utilisateur Page 99