Wavetronix SMARTSENSOR 105 Guide de l'utilisateur télécharger pdf (Page 61)

60 CHAPTER 5  COMMUNICATION

Virtual sensor les can be converted to sensor setup les and can be restored to an actual

sensor; sensor setup les that have been backed up from a sensor can also be converted

to virtual sensor les. To convert a sensor setup le to a virtual sensor le, make a virtual

connection and then use the Restore Sensor Setup tool in the Tools menu. To convert a

virtual sensor le to a sensor setup le, use the Back-up Sensor Setup tool.

Note

To conﬁgure channels for a future installation, connect using a virtual connection,

create a virtual sensor ﬁle and then back up the conﬁguration settings that you cre-

ated. After the ﬁle is successfully backed up, the virtual sensor ﬁle will change to a

sensor setup ﬁle and can be restored to any sensor in the ﬁeld.

When a connection is made to the SmartSensor Matrix, the main menu will appear and all

conguration options will become available (see Figure 5.10).

Figure 5.10 – Main Menu (Connected)

Viewing Connection Information

Once connected, you can view additional information about the connection you have es-

tablished by clicking on the moving arrows icon on the top right of the main menu page or

on the bottom right of the Communication screen (see Figure 5.11). ese arrows are only

visible when there is an established connection.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 106 107

Pas de commentaire

Wavetronix SMARTSENSOR 105 Guide de l'utilisateur Page 61