Wavetronix SMARTSENSOR 105 Guide de l'utilisateur télécharger pdf (Page 87)

86 CHAPTER 8  ZONES & CHANNELS

Channel LED

Pulse

Channel LED

Figure 8.9 – Pulse Channel

Even though the zone stays activated, the contact closure call will only stay on for the time

specied in the pulse channel width setting. You can verify the duration of the pulse chan-

nel calls by viewing the virtual LEDs in the SSMM software. Once you have selected the

pulse channel type, the extend setting will be disabled.

Note

A pulse channel may be dicult to view in the SSMM software. The default pulsed

channel width is 200 ms. To better view the pulse channel activation, increase the

pulsed channel width in the output settings window (see the Output Settings sec-

tion below).

Mapping Zones to Channels

After the zones are placed, the zones must be mapped to output channels. Channel map-

ping is described in the following sections.

Zone/Channel Map

e Zone/Channel map allows you to map or un-map zones to channels (see Figure 8.10).

To map a zone to a channel, determine which zone you want to map to which channel and

click on the gray indicator in the Zones/Channels table. A zone is mapped to a channel

only if the corresponding indicator is green. To see Channels 9–16, click and drag anywhere

inside the table.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 106 107

Pas de commentaire

Wavetronix SMARTSENSOR 105 Guide de l'utilisateur Page 87