Wavetronix SMARTSENSOR 105 Guide de l'utilisateur télécharger pdf (Page 75)

74 CHAPTER 7  LANES & STOP BARS

Figure 7.8 – Save Changes Dialog

Moving the Sensor View

e SSMM software shows the position of the SmartSensor Matrix and the view is drawn

from the perspective of the sensor. e sensor’s default position is in the bottom-left corner

of the display. If the perspective in the software does not match your perspective of the

roadway, click the Rotate View button until the sensor position matches the approach you

are conguring.

Note

Moving the sensor in the software will have no eect on the sensor’s performance.

Its purpose is to facilitate the conﬁguration process.

Restarting Auto Lane Conﬁg/Rebooting the Sensor

Restarting the automatic lane conguration will erase any auto-conguration information

that may have been gathered and will start the auto-conguration process over again.

Rebooting the sensor will also erase any auto-conguration information, but in addition

will clear and recongure the sensor thresholds.

Follow the steps below to restart the automatic lane conguration process or reboot the

sensor:

1 Click the Restart/Reboot button and the Restart or Reboot window will appear (see

Figure 7.9).

2 Select the appropriate radio button and click OK.

Figure 7.9 – Restart or Reboot Window

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 106 107

Pas de commentaire

Wavetronix SMARTSENSOR 105 Guide de l'utilisateur Page 75