Wavetronix SMARTSENSOR 105 Guide de l'utilisateur télécharger pdf (Page 47)

46 CHAPTER 4  INSTALLING SMARTSENSOR MANAGER MATRIX

Wireless

Wired

Figure 4.1 – Install Kit

e Click 421 converts wired or wireless serial data to RS-485 communication and sends

it to all devices on a shared multi-drop communication bus on the backplate. is allows

control of all SmartSensor Matrix units from a single access point.

You can make a wired connection using a USB-to-serial converter and a USB adapter

cable; alternatively, you can make a wireless connection using a precongured Bluetooth

link. A whip antenna can be attached to the Click 421 to increase the distance and reli-

ability of the wireless link.

Note

The install kit can also be used to conﬁgure SmartSensor HD, SmartSensor Advance

and many Click devices.

Using the Click 421

Follow the steps below to use the Click 421 from the install kit to communicate with the

SmartSensor Matrix:

1 Rock the Click 421 device onto the green T-bus to the left of the gray T-bus connector

on the second DIN rail on the backplate.

2 Make a wired (using the serial port on the front of the device) or wireless (Bluetooth)

connection between the Click 421 and the handheld computer.

If you wish to establish a wired connection with a laptop computer instead of the handheld

device, use the laptop’s native RS-232 serial port to connect to the Click 421, or a USB-

to-serial converter if the laptop does not have an RS-232 serial port. You can also establish

a Bluetooth connection from your laptop to the Click 421. To do so, consult your laptop’s

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 106 107

Pas de commentaire

Wavetronix SMARTSENSOR 105 Guide de l'utilisateur Page 47